Barebones 0.5W to 5W Drive Kit com/site/hobbypcbrsuv3awiki/

com/site/hobbypcbrsuv3awiki/

The receiver in the RS-HFIQ consists of 5 band-pass filters to reject out-of-band signals

Bare board to build you own amp

Elecraft or ELAD dongles and need 5V on pin 1 for power

320×240 resolution

Barebones 0.5W to 5W Drive Kit com/site/hobbypcbrsuv3awiki/New REV C Version Increases the use of SMT components, reducing build time and complexity no transformer to wind. Uses the ATU mounting holes so no drilling is required. 0. 5 watts to 5 wattsDriverkit, which can be used as a final amplifier for a QRP project or to upgrade an existing HARDROCK 50 that was purchased without thedriver. SMT parts come pre soldered, and the following through hole parts are supplied: 1 x RD16HHF1 1 x 6" RG 316 2 x 2 pin