Carbide Pin - 40° Tip angle, High Hardness Patmark Plus reducing the contact with the

reducing the contact with the workpiece to just two small metal legs and allowing easier access to the workpiece where the foot would otherwise obstruct access

For example one customer uses this pin to mark the inside of metal caps

Metal (HRC62)

4 screws for mounting the head

MB2S WiFi controller with upgraded chip for rotary unit

Carbide Pin - 40° Tip angle, High Hardness Patmark Plus reducing the contact with theCarbide stylus pin with a 40 tip angle Standard Length: 52mm Carbide hardness: HRA93. 6 Recommended for Plastics This is sharpest tip angle and is recommended for plastics only. The extra hardness would be workable on aluminium or finished steels (think chrome polished) where a fine mark is desired. If you run this tip on steels with a high force setting its will mark, but it will also get worn down fairly quickley and so is not recommened for the