Fibre-reinforced plastics. Methods of producing test plates - Contact and spray-up moulding Ingestion-build-81111 “Non-through porosity” thermal spray aluminium

“Non-through porosity” thermal spray aluminium coatings with greater than 250 μm dry film thickness can be tested and qualified in accordance with ISO 19277

NOTE Sieves with a mesh size smaller than 32 μm are not practical and are likely to become blind during use

Specifying round tube sizes and tolerances

Organizations which design

Construction of drainage field

Fibre-reinforced plastics. Methods of producing test plates - Contact and spray-up moulding Ingestion-build-81111 “Non-through porosity” thermal spray aluminium1 Scope This part of ISO 1268 specifies methods for preparing reinforced plastics test plates either by contact moulding or by spray up moulding. It applies exclusively to glass reinforcements. It is intended to be read in conjunction with ISO 1268 1.