Heat shrinkable moulded shapes - Definitions and general requirements subscription-only contamination with other materials may

contamination with other materials may occur that could affect the product's suitability for recycling into the intended application

C70 and C80

In conjunction with EN 17176-1 and EN 17176-5

this will provide a means to evaluate exposures where there is concern over the inadequacy of mass-based methods

The method specified in BS EN 60512-25-9 provides a means to test the alien (exogenous) crosstalk between any two ports

Heat shrinkable moulded shapes - Definitions and general requirements subscription-only contamination with other materials mayWhat is BS EN 62329 1 Heat shrinkable moulded shapes about? BS EN 62329 1 is a British Standard for Heat shrinkable moulded shapes. BS EN 62329 1 guidelines provide requirements for fixed, surface mounted inductors, to describe terms, to give recommendations for standard values and dimensions and to give guidance on fixed, surface mounted inductors. BS EN 62329 1 is applicable to heat shrinkable moulded shapes in a range of configurations and