Holding fixtures of cylindrical abrasive sleeves - Holding fixtures with shank for hand-held grinding machines Ingestion-build-82061 and low contact resistance use

and low contact resistance use

including type-approval tests for individual components

products with natural skins or with density deviations normally found with such products may be considered acceptable for test by this technique

and regulatory authorities

Two types of PVC-covered conductor have been standardized by the designation of minimum thickness of covering as follows:

Holding fixtures of cylindrical abrasive sleeves - Holding fixtures with shank for hand-held grinding machines Ingestion-build-82061 and low contact resistance use1 Scope This part of ISO 15637 applies to holding fixtures with shank for use with cylindrical abrasive sleeves with D 100 mm in accordance with ISO 2421. Holding fixtures with shank having a diameter D 100 mm mostly have lamellar cores and are used on hand held grinding machines. The impact of centrifugal forces on the lamellae result in an increase in diameter and thereby clamp the abrasive sleeve on to the holding fixture.