Methods for the calibration of vibration and shock transducers - Primary vibration calibration by laser interferometry Ingestion-build-67170 The maximum working pressure is

The maximum working pressure is not greater than 30 bar

describes a method for the determination of the aggregate abrasion value (AAV) which gives a measure of the resistance of aggregates to surface wear by abrasion

The sampling and inoculation devices are used to remove material from or add material to the closed system

falling space

By adopting BS EN 2063

Methods for the calibration of vibration and shock transducers - Primary vibration calibration by laser interferometry Ingestion-build-67170 The maximum working pressure is1 Scope This part of ISO 16063 specifies the instrumentation and procedure to be used for primary vibration calibration of rectilinear accelerometers (with or without amplifier) to obtain magnitude and phase lag of the complex sensitivity by steady state sinusoidal vibration and laser interferometry. It is applicable to a frequency range from 1 Hz to 10 kHz and a dynamic range (amplitude) from 0,1 m s2 to 1 000 m s2 (frequency dependent). These ranges