Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 Part 3 of BS EN

Part 3 of BS EN ISO 22442 does not consider the effect of any method of elimination and/or inactivation on the suitability of the medical device for its intended use

Aims and tolerances should be developed through use-case analysis

They can be found in HD 605

This Part of this European Standard sets out minimum requirements for the specific types of water to reduce the risk of corrosion

and modification of cultural heritage about

Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 Part 3 of BS ENWhat is this standard about? This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. This document is not applicable to crankshaft bearing units in combustion engines.