Test conditions for numerically controlled turning machines and turning centres - Geometric tests for machines with inverted vertical workholding spindles Ingestion-build-276583 It also covers:

It also covers:

these can be made in such a way that they detach or yield under vehicle impact

also known as bottom-up or energy performance improvement actions (EPIAs)-based methods (see ISO 17742)

Design requirements verification

Water is applied under pressure to the surface of hardened concrete

Test conditions for numerically controlled turning machines and turning centres - Geometric tests for machines with inverted vertical workholding spindles Ingestion-build-276583 It also covers:1 Scope ISO 13041 3: 2008 specifies, with reference to ISO 230 1 and ISO 230 7, the geometric tests on general purpose, numerically controlled (NC) turning machines and turning centres with inverted vertical workholding spindles, as well as the corresponding applicable tolerances. This part of ISO 13041 presents the different concepts or configurations and common features of NCturning machines and turning centres with inverted vertical spindles. It