Jack Hammer Adapter Compression Points

Jack Hammer Adapter Compression PointsThis part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole. It basically has 2 holes in it. One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted, 1 1 8" hex bit connected to the jackhammer. Eeither an electric or pneumatic jack hammer having a 1 1 8" hex shank may be used with the jack hammer adapter. NOTE: An Idea is to use an old. worn

the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side

Fits 4 shafts

( Remove The point after marking the pipe)

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

The trajectory of penetration has three settings

The Push Point will have the same as the outside diameter of the pipe itself

Transfer the length of both lines

It is actually 3" in diameter and will make a hole large enough to accommodate a 2" Sch 40 pipe with a coupling

The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

It is designed to absorb lateral forces that the point will experience as it comes in contact with debris from different angles along it's route

At a glance you will know if anything is missing