Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer Ingestion-build-180956 The design of the cables

The design of the cables and connectors used will preferably conform to the applicable parts of IEC 61196 and IEC 61169 respectively

c) for the purpose of noise control at the design stage

Such purposes can be

and if there are specific national rules concerning this type of lift

NOTE 1 The results obtained by this method give an objective measure of the noise emitted under the specified test conditions

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer Ingestion-build-180956 The design of the cables1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.