3" Drain Cap Compression Points

3" Drain Cap Compression PointsAfter the pipe or conduit is installed over the shafts, this part is used to center the pipe or conduit onto the back end of the shafts. Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement.

Fits 4 shafts

The digging hook can be attached to any digging bar that has a square

Next this pipe/point assembly is shoved into the same opening created earlier by the Bullet Mole

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

The angle of penetration can also be adjusted pitch downward from 4° to 15°

This connector is used to connect 1-1/2" poly pipe to the shafts before the shafts are extracted from the ground

After the pipe or conduit is installed over the shafts

After the Push Point is attached to the pipe

The actual diameter of this part is 2" in

4) The Bullet Mole shafts are extracted and the pipe or conduit is pulled into the hole behind them simultaneously

Connect the nozzle to the end of a garden hose and insert it through the hole all the way to the exit pit then

After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point