1-1/4" PVC Push Point Compression Points

1-1/4" PVC Push Point Compression PointsThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or

It should be 5/8 of an inch long

This is used to support the shafts and hold them up off of the ground while they are being driven in

The tool can go further distances by just purchasing additional shafts

This part is made of stainless steel and is used to insert a - 2" "k" or "L" wall copper pipe into the ground after the initial hole is opened with the compression point

This nozzle can be used to moisten and remove soil from a smaller hole after a smaller compression point has been driven through the ground

This pull connector will make a secure and strong connection to any 1-1/2" rolled Polyethylene conduit for fiber optic - Poly pipe for water lines or -Polyethylene pipe for gas lines  Etc

The actual diameter of this part is 2" in

There are 2 half pipe indicator lines cut into the point

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

3) The connector with the attached pipe or conduit is lowered into the exit pit and the opposite end is connected to the male thread of the shaft without having to turn either the pipe or the shafts

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it