1-1/2" Tappered Pull Connector Compression Points

1-1/2" Tappered Pull Connector Compression PointsThis connector is used to connect 1 1 2" poly pipe to the shafts before the shafts are extracted from the ground. This pull connector will make a secure and strong connection to any 1 1 2" rolled Polyethylene conduit for fiber optic Poly pipe for water lines or Polyethylene pipe for gas lines Etc (One size fits all types) It has a swivel between the two ends with lateral wobble. This unique design combination allows for the female threaded end of the

(1) Quick shaft

It should be 5/8 of an inch long

One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted

As the point emerges into the exit pit

NOTE: This part is rarely used but in the case of loose gravel or roots pushing back into the hole

The Push Point will have the same as the outside diameter of the pipe itself

It requires a very shallow and short entrance trench approx 6 Inches deep and 24 to 30 inches long depending on the angle

worn steel bit and cut off the end so that it will be blunt

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

It is designed to absorb lateral forces that the point will experience as it comes in contact with debris from different angles along it's route

Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement

or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling